Work on glueing the stringers has started. I decided not to screw them into the frames as the designer suggests because my frames are made out of a simple thickness of ply so there is not enough material for the screw to bite into. For the same reason the risk of splitting the frame would be high.
I have rather used thickened epoxy and short lengths of glass tape set in epoxy to bind the stringers to the frames and keep them securely in place. The result is very satisfactory.... tough, sturdy and no screw heads to negotiate when beveling stringers and planks.
I followed fellow pathfinder builders lead and split the stringers in half for short lengths at strategic locations where the bend was such that things were getting a little too strained for my likely . Alos the setting up required liberal use of powerful clamps ....
I will stop at two stringers each side to allow dry fitting the bunkflat and seat tops before carrying on glueing the remaining top two stringers each side...
No comments:
Post a Comment